1088706 PHOENIX CONTACT -

Notes	General: NOTE: Only qualified electrical personnel may install and start up the IPD components. NOTE: Risk of fatal electric shock Never insert or remove the protective cap when the connector is under load or connected to power. For electrical values, refer to the current-carrying product.
Product properties	Product family: IPD Retaining cord present: no Data management status Article revision: 00 Insulation characteristics Degree of pollution: 3
Dimensions	Width: 26 mm
Material specifications	Color: light gray (RAL 7035) Material Protective cap: PA Material Seal: NBR Flammability rating according to UL 94: V0
Cable/line	Halogen-free: yes
Mechanical properties	Mechanical data Insertion/withdrawal cycles: 50
Environmental and real-life conditions	Ambient conditions Degree of protection: IP66 IP68 (2 m / 24 h) IP69K Ambient temperature (operation): -30 °C ... 100 °C Resistance to UV radiation: yes
Mounting	Mounting type: Ã¢Ã¢¬¢ Position the protective cap centrally in front of the counterpart. The Phoenix Contact logo must be at the top on both mating elements. Make sure that the coding pin is located outside the pin connector pattern.Ã¢Ã¢¬¢ The connection is coded and only snaps into place in one position. The rotary element automatically locks the connection and reaches its starting position again. Ã¢Ã¢¬¢ The STS KN6031 2,2x6 thermoplastic screw (or similar items) can be used in the bore hole provided (torque: 0.2 Nm) to secure the protective cap to an IPD panel feed-through. Assembly note: Ã¢Ã¢¬¢ Position the protective cap centrally in front of the counterpart. The Phoenix Contact logo must be at the top on both mating elements. Make sure that the coding pin is located outside the pin connector pattern. Ã¢Ã¢¬¢ The connection is coded and only snaps into place in one position. The rotary element automatically locks the connection and reaches its starting position again. Ã¢Ã¢¬¢ Make sure that the inside of the protective cap is clean and dry before fitting it. Ã¢Ã¢¬¢ The self-locking rotary elements of the IPD PL CAP... protective cap and the IPD PL... connector are provided with a coding pin. Make sure not to damage the coding pin.