Not available 
| Product properties | Product type: Solid-state relay module Product family: PLC-INTERFACE Application: Output function Operating mode: 100% operating factor Insulation characteristics Insulation: safe isolation Insulation characteristics: Air clearances and creepage distances between the power circuits Insulation: safe isolation Overvoltage category: III Pollution degree: 2 |
| Electrical properties | Test voltage: 4 kVrms (50ÃHz, 1Ãmin., winding/contact) Air clearances and creepage distances between the power circuits Rated insulation voltage: 260 VÃAC Rated surge voltage: 6 kV |
| Input data | Rated control circuit supply voltage US: 24 VÃDC Voltage range with reference to US: 0.8 ... 1.2 Rated control supply current IS: ââ°¤ 19 mA Rated actuating voltage UC: 24 VÃDC Voltage range with reference to UC: 0.8 ... 1.2 Rated actuating current IC: 6.8 mA "0" signal switching threshold in reference to UC: < 0.4 "1" signal switching threshold in reference to UC: > 0.8 Typical response time: 30 ms Typical turn-off time: 20 ms Status display: Yellow LED Protective circuit: Reverse polarity protection Surge protection Surge voltage protection: > 33 VÃDC Transmission frequency: 1 Hz |
| Output data | Designation: AC hybrid output Contact switching type: 1 N/O contact Design of digital output: electronic Output voltage range: 24 VÃAC ... 253 VÃAC (50/60ÃHz) Limiting continuous current: 10 A (see derating curve) Min. load current: 100 mA Leakage current: < 1 mA Surge current: 250 A (tp = 20Ãms, at 25ðC) Max. load value: 350 A2s (tp = 10Ãms, at 25ðC) Surge voltage protection: > 275 V Output circuit: 2-conductor, floating Protective circuit: Varistor |
| Connection data | Connection method: Screw connection Stripping length: 8 mm Screw thread: M3 Conductor cross section rigid: 0.14 mm² ... 2.5 mm² Conductor cross section flexible: 0.14 mm² ... 2.5 mm² 0.2 mm² ... 2.5 mm² (Single ferrule) 2x 0.5 mm² ... 1.5 mm² (TWIN ferrule) Conductor cross section AWG: 26 ... 14 Tightening torque: 0.45 Nm ... 0.55 Nm (Usually these terminal blocks must be supported during conductor connection (held by one hand, supported on the housing)) |
| Dimensions | Width: 14 mm Height: 80 mm Depth: 94 mm |
| Environmental and real-life conditions | Ambient conditions Degree of protection (Relay base): IP20 (Relay base) Degree of protection (Relay): RT II (Relay) Degree of protection (Installation location): IP54 (Installation location) Ambient temperature (operation): -25°C ... 60°C Ambient temperature (storage/transport): -40°C ... 85°C Altitude: ââ°¤ 2000 m |
| Approvals | Corrosive gas test Identification: ISA-S71.04. G3 Harsh Group ENÃ60068-2-60 |
| Standards and regulations | Air clearances and creepage distances between the power circuits Standards/regulations: IEC 60947-5-1 |
| Mounting | Mounting type: DIN rail mounting Assembly instructions: See derating curve Mounting position: any |
Description other products
